def getNimConfig(self, slotid):
return config.Nims[slotid]
+
+ def getSatName(self, pos):
+ for sat in self.satList:
+ if sat[0] == pos:
+ return sat[1]
+ return _("N/A")
def getSatList(self):
return self.satList
x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_TONEBURST, configElement.value))
config.sec.delay_after_toneburst = x
+ x = ConfigInteger(default=20, limits = (0, 9999))
+ x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_VOLTAGE_CHANGE_BEFORE_SWITCH_CMDS, configElement.value))
+ config.sec.delay_after_change_voltage_before_switch_command = x
+
x = ConfigInteger(default=200, limits = (0, 9999))
x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_ENABLE_VOLTAGE_BEFORE_SWITCH_CMDS, configElement.value))
config.sec.delay_after_enable_voltage_before_switch_command = x
x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_BETWEEN_SWITCH_AND_MOTOR_CMD, configElement.value))
config.sec.delay_between_switch_and_motor_command = x
- x = ConfigInteger(default=150, limits = (0, 9999))
+ x = ConfigInteger(default=500, limits = (0, 9999))
x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_VOLTAGE_CHANGE_BEFORE_MEASURE_IDLE_INPUTPOWER, configElement.value))
config.sec.delay_after_voltage_change_before_measure_idle_inputpower = x
x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_ENABLE_VOLTAGE_BEFORE_MOTOR_CMD, configElement.value))
config.sec.delay_after_enable_voltage_before_motor_command = x
- x = ConfigInteger(default=150, limits = (0, 9999))
+ x = ConfigInteger(default=500, limits = (0, 9999))
x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_MOTOR_STOP_CMD, configElement.value))
config.sec.delay_after_motor_stop_command = x
- x = ConfigInteger(default=150, limits = (0, 9999))
+ x = ConfigInteger(default=500, limits = (0, 9999))
x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_VOLTAGE_CHANGE_BEFORE_MOTOR_CMD, configElement.value))
config.sec.delay_after_voltage_change_before_motor_command = x
x.addNotifier(lambda configElement: secClass.setParam(secClass.MOTOR_COMMAND_RETRIES, configElement.value))
config.sec.motor_command_retries = x
- x = ConfigInteger(default=20, limits = (0, 9999))
- x.addNotifier(lambda configElement: secClass.setParam(secClass.DELAY_AFTER_VOLTAGE_CHANGE_BEFORE_SWITCH_CMDS, configElement.value))
- config.sec.delay_after_change_voltage_before_switch_command = x
-
# TODO add support for satpos depending nims to advanced nim configuration
# so a second/third/fourth cable from a motorized lnb can used behind a
# diseqc 1.0 / diseqc 1.1 / toneburst switch